12 — ENG
D20247
STARTING YOUR PRESSURE
WASHER
NOTE: Make sure water supply is turned on.
Never turn water supply off while pressure
washer engine is running or damage to
pump will result.
1. Move choke control to CHOKE position.
NOTE
To restart a warm engine, move choke control
to RUN position.
OPERATION
PRE-START CHECKLIST
Once you reach this point, ensure you have com-
pleted the following:
3
All safety instructions read and understood?
3
All hose connections are tightened and free of
any kinks, damage, or leaks?
3
Correct amount of engine oil and gasoline
added to engine?
3
Water supply (garden hose) turned on?
3
All operation instructions read and under-
stood?
If you can say "yes" to the items in the Pre-start
Checklist, you are ready to start your pressure
washer.
TYPICAL HOOK-UP
Your pressure washer hookup should resemble this
diagram.
Garden
Hose
Chemical
Chemical
Hose
Hi-
Pressure
Hose
Pressure Washer
Wand
2. Move throttle control to FAST position.
3. Pull starter grip slowly until you feel resistance,
then pull briskly. Return starter grip gently.
Choke Control
If engine does not start after two pulls, pull
the trigger on spray gun to relieve pressure
in hose. Failure to do so may cause dam-
age to starter recoil mechanism of engine
NEVER RUN ENGINE INDOORS OR IN EN-
CLOSED, POORLY VENTILATED AREAS. EN-
GINE EXHAUST CONTAINS CARBON MON-
OXIDE, AN ODORLESS AND DEADLY GAS.
4. When engine starts, gradually move choke lever
from one position to the next until it is in the full
RUN position.
Throttle
Control
FAST SLOW STOP
Starter Grip
NEVER FILL FUEL TANK COMPLETELY. FILL
TANK TO 1/2" BELOW BOTTOM OF FILLER
NECK TO PROVIDE SPACE FOR FUEL EX-
PANSION. WIPE ANY FUEL SPILLAGE FROM
ENGINE AND EQUIPMENT BEFORE START-
ING ENGINE.
To Next Page
Loading...
