8
A-3655X
EN
OPERATION
7. Assemble mouthpiece and t-piece (if applicable) and
insert into the top of the nebulizer cap. If using an
aerosol mask, insert the bottom part of the mask
directly into the top of the nebulizer cap.
8. Attach tubing to nebulizer air-inlet connector (Fig. 4).
9. Press the power switch “ ” (Fig. 1) to start the
compressor.
10. Begin treatment by placing the mouthpiece between
teeth. With mouth closed, inhale deeply and slowly
through mouth as aerosol begins to flow, then exhale
slowly through the mouthpiece (Fig. 5). If treatment
needs to be interrupted, simply press power switch “
” and place the nebulizer into the nebulizer holder
(Fig. B).
NOTE– Your physician may recommend a specific
breathing pattern during treatment. If so, follow his/
her recommendations.
11. If an aerosol mask is used, place the mask over mouth
and nose (Fig. 6). As aerosol begins to flow, inhale
deeply and slowly through mouth, then exhale slowly.
12. When treatment is complete, turn unit off by pressing
the power switch to the “ ” position. Unplug the unit
from the wall power outlet.
13. Cord storage can be done by holding the compressor
by its handle and wrapping the cord clockwise around
the compressor (Fig. 7).
4
5
6
7
To Next Page
Loading...
