DeVilbiss AG360 Series - Fluid Tip

EN
C
TE
HV
U - TE10 - 085N - L F P
U P
L F
S M
T
C1
C2
C3
TE10
TE20
TE30
TE40
TE50
HV30***
R40
*
**
***
150-200 ml/min
Air Consumption
290 L/min [10.3 cfm]
440 L/min [15.7 cfm] 3 Bar [45 psi]
Trans-Tech/Compliant 2 Bar [30 psi]255 L/min [9.1 cfm] 300mm
250-600 ml/min
See table 1
Recommended
Air Inlet Pressure
PROC-120-C1-K
Air Cap & Type
Conventional
See pages 8 & 10
Single hole head feed
Head recirculation
HVLP
Trans-Tech/Compliant
100-350 ml/min
150-200 ml/minTrans-Tech/Compliant
PROC-120-C2-KConventional
Conventional
PRO-100-TE10-K
Part Number
PROC-120-C3-K
300 L/min [10.7 cfm] 3 Bar [45 psi]
325 L/min [11.6 cfm]
FLUID TIP
AG362
AIR CAP
PRO-100-TE40-K
Trans-Tech/Compliant
355 L/min [12.6 cfm]Trans-Tech/Compliant
PRO-100-TE30-K
GUN HEAD FLUID PASSAGEWAYS
TABLE 1 - AG362 AIR CAP PERFORMANCE GUIDE
VALVE OPTIONS
BACK END OPTIONS
Control Valve
Plugged
Gun only
Screw manifold - recirculation
Lever manifold
Screw manifold - no recirculation
200-300 ml/min
Trans-Tech/Compliant 2 Bar [30 psi]
PRO-100-HV30-K
PRO-100-TE50-K
Flow rates may vary according to paint/material and pressure used.
2 Bar [30 psi]450 L/min [16.0 cfm]
250-400 ml/min
160-200 ml/min
425 L/min [15.1 cfm]
HV30 (HVLP) operates at 0.7 Bar [10 psi] atomisation air pressure at the cap.
300mm
HVLP 315mm
300mm
380mm
2 Bar [30 psi]
2 Bar [30 psi]
270mm
270mm
360mm
Fixed
Micrometer
290mm2 Bar [30 psi]
Typical Fan
Pattern Size**
250-400 ml/min
375 L/min [13.3 cfm]
3 Bar [45 psi]
See table 2
150-250 ml/min
Typical Fluid
Flow*
Conventional
PRO-100-TE20-K
Ratchet
MANIFOLD TYPE
Size & construction
AG362 GUN PART NUMBER FORMAT & PART SELECTION GUIDE
Fan pattern size @ 200mm distance.
Trans-Tech/Compliant PRO-102-R40-K 110 L/min [4.0 cfm] 3 Bar [30 psi] 150-300 ml/min 70mm
SB-E-2-643 R5.0
5/28