Operating the device
The Onyx speakers can be used for different purposes, but it's important to be aware of the following
information beforehand in order to achieve optimal performance.
Warning before use
Devine's Onyx speakers are capable of producing volume levels that can cause temporary or permanent
hearing damage. Use these units with care and keep the volume at a reasonable level when possible. The
volume should ideally be set to a comfortable level when listening to music.
Devine cannot be held liable for any injuries or damage resulting from the use of this product.
General use
Housing
The Onyx speaker has a robust housing made of moulded plastic. While this is designed to withstand regular
mobile use, it is not designed to withstand falls or damage by (relatively) sharp objects.
During use, storage and transport, ensure that the speaker cannot fall or be damaged by nearby objects that
could fall or move.
Handles
The Onyx speakers are all equipped with a handle on the top. The 10-inch version also has one handle on
the side, while the 12-inch and 15-inch versions have extra handles on both sides.
The handles are designed to make it easier to pick up and move the speakers only. They should never be
used as part of the speaker's installation. The use of harnesses or tension straps is not recommended when
stacking the speaker on top of a subwoofer, for instance. If you do decide to use harnesses or straps,
however, ensure that the handles are not subjected to great forces as this is likely to cause damage.
Protection during transport
While the Onyx speakers can be transported, they are not waterproof and caution is therefore advised if they
taken outside during rain or in adverse weather conditions. If they are exposed to moisture in any form,
ensure that they are completely dry again before use. Failure to do so may result in a short circuit which
could cause permanent damage or injury. Exposure to moisture can also cause visible or invisible corrosion
which may cause damage in the long term.
Grille
The Onyx speakers are equipped with a metal grille on the front to protect the speaker components behind.
There is also acoustic foam behind the grille to prevent any unwanted matter from getting inside the speaker.
The grille should therefore not be removed.
Stand flange
The speaker is equipped with a 35 mm stand flange on the bottom which allows it to be easily mounted on a
stand. From an elevated position, the speaker's high tones will travel further thereby reaching a larger
audience.
For optimal sound dispersion, the middle of the speaker's woofer should ideally be placed at a height of
between 1.80 and 2.00 metres.
By means of a knob, the stand flange can be tightened to hold the speaker firmly in place on the stand. As
well as being secure, this also prevents undesirable vibrations and resonance.
When the speaker is mounted on a stand, make sure that the stand is not placed anywhere it will be in the
way and/or could be knocked over. The legs on a stand should always be fully extended to ensure optimal
stability.
The 35 mm stand flange can also be used to mount the speaker on a suitable wall bracket. Consult the
The information in this user manual is subject to change at any time without notice.
Version: 1.0 Date of creation and author's initials 23-09--2017 RV Revision date and author's initials: -
To Next Page
Loading...
