Devine VersaKey 88 - Appendix E-Assignable Controller Numbers to Non-Linear Controllers; Appendix F - Assignable Controller Numbers to Rotary Encoders; Appendix G - Assignable Controller Numbers to Pressure Pads

Appendix E-Assignable Controller Numbers to Non-Linear
Controllers
The contents of this table only apply to the following control elements of the VersaKey:
Transport Section, Sustain Pedal
0-127 General controller
128 PAD controller
129 Pitch Bend
130 Master Volume
131 Program Change
132 RPN Coarse
133 RPN Fine
134 NRPN Coarse
135 NRPN Fine
Appendix F – Assignable Controller Numbers to Rotary
Encoders
The contents of this table only apply to the rotary encoders of the VersaKey:
0-127 General controller
128 PAD controller
129 Pitch Bend
130 Master Volume
131 Program Change
132 RPN Coarse
133 RPN Fine
134 NRPN Coarse
135 NRPN Fine
Appendix G – Assignable Controller Numbers to Pressure Pads
The contents of this table only apply to the drum pads of the VersaKey:
0-127 General controller
128 PAD controller
129 Pitch Bend
130 Master Volume
131 Program Change
132 RPN Coarse
133 RPN Fine
134 NRPN Coarse
135 NRPN Fine
The information included in this user manual is subject to change at any time and without notification:
Version:
1.0
Date and author initials: 02-11-2020 RV Revision date and author initials: -