6
Control Panel
Fig.2 Control Panel
OPERATION
Getting Started
• Carefully remove the heater from the box and keep the carton for off-season storage.
• Ensure the power switch (13) is turned off before plugging the unit in.
• Make sure the heater is safely installed in accordance with the installation instructions.
• It is best to avoid using the heater in an outlet that is already being used for other high-
power electrical equipment, to avoid overloading the circuit.
Power On
• When the product is connected to the power supply, the power indicator (1) will illuminate,
and the Wi-Fi indicator (12) will begin to flash.
• Press the power button (9) to switch the unit on.
Power Off
• Hold the power button (9) for three seconds to switch the unit off.
Half Power and Full Power Selection
• Press the heating power button (8) to change the power to partial or full load.
• At full heating capacity, “HI” is shown in the display (3) and the half heating capacity (2)
"LO" is deactivated.
• In the case of partial capacity heating, "LO" is activated on the display (2) and "HI" is
deactivated on the display (3).
1. Power Indicator
2. Half Power Indicator (LO)
3. Full Power Indicator (HI)
4. Heating Indicator
5. Temperature Measure (℃)
6. Upward Adjustment Button
7. Downward Adjustment Button
To Next Page
Loading...
