page 16Manual_Revised_V1.1
14. Risk of electric shock. Do not touch the
uninsulated portion of output connector or
uninsulated battery terminal.
ADDITIONAL SAFETY RULES
FOR TOOL
1. Use suitable detectors to determine if
utility lines are hidden in the work area
or call the local utility company for
assistance. Contact with electric lines can
lead to re and electric shock. Damaging a
gas line can lead to explosion. Penetrating a
water line causes property damage.
2. Switch off the power tool immediately
when the tool inserts jams. Be prepared
for high reaction torque that can cause
kickback. The tool insert jams when:
--the power tool is subject to overload or
--it becomes wedged in the workpiece.
3. Hold the power tool only by the insulated
grpping surfaces, when performing an
operation where the cutting tool may run
into hidden wiring. Contact with a “live”
wire will make exposed metal parts of the
tool “live” and shock the operator.
4. Hold the power tool with a rm grip. High
reaction torque can briey occur while driving
in and loosening screws.
5. Secure the workpiece. A workpiece
clamped with clamping devices or in a vice is
held more secure than by hand.
6. Keep your workplace clean. Blends of
materials are particularly dangerous. Dust
from light alloys can burn or explode.
7. Always wait until the power tool has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
8. The tool can only be used with battery
No.5150 together.
9. Never use the battery pack as a hammer,
beat the battery pack could result in accident
short,re or explode.
WARNING: Some dust created by
power Cutting contains chemicals known
to cause cancer, birth defects or other
reproductive harm. Some examples of these
chemicals are:
■
lead from lead-based paints
■
Arsenics and chromium from chemically
reacted lumber.
Your risk from these exposures varies,
depending on how often you do this type
of work. To reduce your exposure to these
chemicals: work in a well ventilated area, and
work with approved safety equipment.
ACCESSORIES
● Rotary Hammer
● Charger
● Lithium-Ion Battery pack
● Auxiliary handle
Be sure to check the accessories as it is
subject to change by areas and models.
OPERATION
1. Check the power voltage must be
consistent with the nameplate data!
2.BATTERY CHARGING
The battery is supplied partially charged. To
ensure full capacity of the battery, completely
charge the battery in the battery charger before
using your power tool for the rst time.
- A fully discharged battery pack will charge
in about 45 minutes in a surrounding
temperature between 32° F (0° C) and 104° F
(40° C).(With 5339 Charger)
- A fully discharged battery pack will charge
in about 100 minutes in a surrounding
temperature between 32° F (0° C) and 104° F
(40° C).(With 5340 Charger)
1) Charge the Lithium-Ion battery pack with the
correct charger.
2) Connect the charger to a power supply.
To Next Page
Loading...