Need help?Do you have a question about the DeWalt 7790 Type 6 and is the answer not in the manual?
Adjusting the rip scale for "in rip" and "out rip" positions.
Adjusting the miter scale pointer to 0 for straight cross-cuts.
Adjusting the bevel scale pointer to 0 for vertical cuts.
Adjusting bevel clamp handle for rigid motor positioning.
Adjusting rollerhead bearings for smooth, accurate movement.
Adjusting arm clamp handle for desired position.
Adjusting base to column for side motion and rotation.
Ensuring table top surface is parallel to arm tracks.
Aligning blade perpendicular to work top using a square.
Aligning arm for square cross cuts with guide fence.
Ensuring blade teeth follow arm tracks precisely.
Checking table top and guide strip straightness with a square.
Adjusting yoke clamp handle for proper friction lock.
Explains the manual-reset overload protector function.
How to position the arm for miter cuts.
How to swivel the yoke for rip cuts.
How to tilt the motor for bevel cuts.
Instructions for performing a standard cross cut.
Instructions for performing a miter cut.
Instructions for setting up and performing rip cuts.
Instructions for performing a bevel cut-off.
Instructions for performing a plough cut.
Instructions for performing a compound miter cut.
Instructions for performing a rabbet cut.
Instructions for performing a bevel rip cut.
Instructions for performing shaping operations.
Instructions for using a dado head.
Instructions for using the disc sander.
To Next Page
General
