Need help?Do you have a question about the DeWalt 3436 Type 6 and is the answer not in the manual?
Details for connecting the saw to a 208-240 Volt power supply.
Details for connecting the saw to a 120 Volt power supply.
Adjusting rip, miter, and bevel scales for accurate angle cuts.
Verifying table top and guide fence straightness for accurate cuts.
Adjusting yoke clamp for rollerhead stability and movement.
Adjusting bevel clamp handle for secure motor positioning.
Adjusting rollerhead bearings for smooth, accurate movement.
Adjusting arm clamp handle for secure arm positioning.
Adjusting base to column for eliminating side motion.
Ensuring table top is parallel with arm tracks.
Aligning blade perpendicular to work top.
Aligning cross cut travel with the guide fence.
Ensuring cross-cut travel is parallel to arm tracks.
Understanding and resetting the motor overload protector.
Rotating the arm left or right for miter cuts.
Performing a standard cross cut operation.
Performing a miter cut operation.
Setting up the machine for in-rip and out-rip cuts.
Performing a cut with the blade tilted.
Performing a cut combining bevel and miter angles.
Using the saw for dado cuts.
Using the disc sander attachment.
To Next Page
General
