DeWalt D28108-XE - Page 4

MOUNTING SIDE HANDLE (Fig. 1)
• Screw the side handle (5) tightly into one of the
holes (17) on either side of the
gear case.
FITTING AND REMOVING GUARD
(Fig.2).
(
D28128-XE
&
D28154-XE)
D28128-XE,
• Place the angle grinder on a table, spindle up.
• Release the clamping lock (6) and hold the guard (4) over the tool as shown
• Align the lugs (7) with the notches (8).
• Press the guard down and rotate it to the required position.
• Tighten the clamping lock (6)
• If required, increase the clamping force by tightening the screw (9)
.
FITTING AND REMOVING GUARD
(Fig.2a). (D28108-XE)
Place the angle grinder on a table, spindle up. Align the lug on the guard with the slot in the
plate. Press the guard down and turn the guard anti-clockwise (in the direction of the arrow).
NOTE: The guard locking spring prevents the guard from coming loose.
FITTING AND REMOVING GRINDING OR CUTTING DISC
Place the tool on a table, guard up.
• Fit the inner flange (10) correctly onto the spindle (11) .
• Place the disc (12) on the flange (10). When fitting a disc with a raised center, make sure that
the raised centre (13) is facing the flange (10).
• Screw the outer flange (14) onto the spindle (11) (fig. 4):
the ring on the flange (14) must face towards the disc when fitting a grinding disc;
the ring on the flange (14) must face away from the disc when fitting a cutting disc .
4
Fig. 1
Never use tool with out guard in place
17
17
Fig. 2
Fig. 3
Fig. 3a
10
12
14
11
3
13
Fig. 2a
5
6
7
4
9
8
15
14