DeWalt D28108-XE - Page 5

5
• Press the spindle lock (3) and rotate the spindle (11) until it locks in position.
• Tighten the flange (14) with the two-pin spanner (Fig.3) (15) supplied.
• Release the spindle lock.
• To remove the disc, loosen the flange (14) with the two-pin spanner (Fig.3)(15)
.
FITTING A BACKING PAD (FIG. 4.)
T
o fit the pad:
To fit the pad: T
1.
Unplug the tool.
2.
Insert the backing pad (15) onto the machine spindle. (11)
3.
Position the abrasive disc (16) on the pad.
4.
Screw the outer flange (13) with the two grip holes, together with the pad fitted, onto the
machine spindle.
5.
With your finger firmly on the spindle lock, tighten the outer flange with the pin spanner
supplied.
6.
Release the spindle lock. You can now plug the tool in and start work.
7.
To remove the backing pad, follow the instructions in reverse order.
FITTING A WIRE CUP BRUSH
•
Screw the wire cup brush directly onto the spindle without using the spacer and
threaded flange
OPERATION
Switch
• To run the tool, press the on/off switch (1).
• For continuous operation, press the switch completely forward.
• To stop the tool, release the switch. To stop the tool in continuous operation, press
on back part of the switch.
Instructions for use.
Do not exert side pressure on a cutting disc.
• Always observe the safety instructions and applicable regulations.
• Ensure all materials to be ground or cut are secured in place.
• Apply only a gentle pressure to the tool.
• Avoid overloading. Should the tool become hot, let it run a few minutes under no
load condition.
Prior to operation:
• Install the guard and appropriate disc or wheel. Do not use excessively worn discs
or wheels.
• Be sure the inner and outer flange are mounted correctly.
• Make sure the disc or wheel rotates in the direction of the arrows on the accessory
and the tool.
Fig. 5
1
Do not use a damaged disc.
13
16
15 11
13
16
Fig. 4