DeWalt D51845 - Page 26

26
ENGLISH
Perform the following maintenance operations every
day:
Lubricate tool with 10-15 drops of DEWALT
pneumatic tool oil
• Insert drops into the air fitting on the end cap of
the tool.
Drain all condensation from the air compressor
tanks and hoses
• Open petcocks or other drain valves on the
compressor tanks.
• Allow any accumulated water to drain from hoses.
Clean magazine, pusher, and contact trip
mechanism
• Clean by blowing with compressed air.
Ensure that all fasteners on the tool are tight and
undamaged
• Tighten loose fasteners using the appropriate tool.
Troubleshooting
If your tool seems not to operate properly, follow the
instructions below. If this does not solve the
problem, please contact your repair agent.
Tool does not work
• Check the air supply.
• If the temperature is low, warm the tool up.
Tool has insufficient power
• Check the air supply.
• Check if the air exhaust is clear.
• Lubricate the tool.
Top cap leaks air
• Tighten the cap screws.
Tool skips nails
• Check the air supply.
• Lubricate the tool.
• Clean the magazine and nosepiece.
• Check that the magazine latch is holding the
magazine firmly.
Fasteners jam in tool
• Make sure only to use fasteners of the type
specified.
• Check that the magazine latch is holding the
magazine firmly.
• Tighten the nosepiece screws.
Unwanted tools and the environment
Take your tool to an authorized DEWALT repair agent
where it will be disposed of in an environmentally
safe way.