DeWalt D55141 - User Manual

Questions and Answers

A
Amy SmithJul 26, 2025
What to do if the pressure gauge drops when using an accessory with my DeWalt Air Compressor?
- O
  Olivia ClarkJul 27, 2025
  If the pressure reading on the regulated pressure gauge drops when an accessory is used with your DeWalt Air Compressor, it might be due to loose tube fittings. Tighten the fittings where you hear air escaping, and check them using a soapy water solution. Be careful not to overtighten the fittings.
K
Kayla HuffmanAug 5, 2025
What to do if the safety valve pops off on my DeWalt D55141?
- M
  Michael Schaefer IIAug 5, 2025
  If the safety valve on your DeWalt Air Compressor pops off due to excessive air tank pressure, it could be due to several reasons. First, the pressure switch may not be shutting off the motor when the compressor reaches the cut-out pressure. In this case, immediately set the On/Off switch to OFF. If the unit still doesn't shut off, contact a DeWALT factory service center or a DeWALT authorized service center. Another potential cause is that the pressure switch cut-out is set too high; in this case also contact a DeWALT factory service center or a DeWALT authorized service center. Finally, check if the tube fittings are not tight enough. If you hear air escaping, carefully tighten the fittings. Use a soapy water solution to check for leaks, but be careful not to overtighten them.
C
Chad SchmidtAug 16, 2025
Why does the safety valve pop off on my DeWalt D55141 Air Compressor?
- V
  Veronica WoodsAug 16, 2025
  If the safety valve on your DeWalt Air Compressor pops off due to excessive air tank pressure, it could be because the pressure switch isn't shutting off the motor when the compressor reaches its cut-out pressure, or the pressure switch cut-out is set too high. Set the On/Off switch to OFF, if the unit does not shut off contact a DEWALT factory service center or a DEWALT authorized service center.