To Next PageTo Next PageWhat to do when DeWalt DC618 Nail Gun headlights are on, motor runs, but the driver blade is stuck down?
If your DeWalt Nail Gun's headlights are on, the motor runs, but the driver blade is stuck down, it could be due to a damaged return system (replace return system; see authorized service center), debris in the nosepiece (clean nosepiece), or a damaged driver/return assembly (replace driver/return assembly; see authorized service center).
Why won't my DeWalt DC618 actuate, even though the headlights are on and the motor runs?
If your DeWalt Nail Gun's headlights are on and the motor runs, but it still won't actuate, it could be due to damaged internal electronics. In this case, you should see an authorized service center.
What to do if my DeWalt DC618 Nail Gun doesn't turn on?
If your DeWalt Nail Gun doesn't turn on, here are some things to check: The tool's internal electronics may need a reset. Remove the battery, wait 3 seconds, and then reinsert it. The battery charge could be low, or the battery might be damaged; in this case, charge or replace the battery. Ensure the contact trip lock is unlocked. If these steps don't solve the problem, the terminals may be dirty or damaged, the contact trip might be bent, or there could be damage to the internal electronics. In these cases you should see authorized service center.
General| Magazine Capacity | 110 Nails |
|---|---|
| Power Source | 18V Battery |
| Depth Adjustment | Yes |
| Jam Clearing | Tool-Free |
| Firing Mode | Sequential |
Safety guidelines for the work environment, electrical hazards, and personal protection.
Addresses safe use of tools, batteries, and servicing.
Further safety instructions specific to nailer operation.
Explains the sequential and bump action triggering modes.
Procedures for loading fasteners into the nailer.
How to adjust drive depth and information on headlights.
Routine cleaning and upkeep of the tool.
Steps to remove jammed fasteners from the nosepiece.
Details on product registration and warranty coverage.
Solutions for common tool problems.
