What to do if my DeWalt DCC2560 Air Compressor has a defective air tank?
The air tank must be replaced; do not attempt to repair the leak. WARNING: There is a risk of bursting. Do not drill into, weld, or otherwise modify the air tank, as this will weaken it and could cause it to rupture or explode.
Why does my DeWalt DCC2560 Air Compressor keep running?
If the pressure switch on your DeWalt Air Compressor doesn't shut off the motor when it reaches the cut-out pressure, set the Auto On/Off switch to "Off" and remove the battery. If it still does not shut off, contact a DeWALT factory service center or a DeWALT authorized service center.
What to do if pump does not run because tank pressure is above cut-in pressure on DeWalt DCC2560?
If the pump on your DeWalt Air Compressor doesn't run because the tank pressure is above the cut-in pressure, drain the tank until the pressure drops below the cut-in point. The pump should then turn on.
What to do if regulator is damaged on DeWalt Air Compressor?
If the regulator on your DeWalt Air Compressor is damaged, it needs to be replaced.
What to do if pump does not run due to safety fault on DeWalt DCC2560?
If the pump on your DeWalt Air Compressor doesn't run due to a safety fault, cycle the Auto On/Off Switch from "Off" to "Auto On."
What to do if tube fittings are not tight enough in my DeWalt DCC2560 Air Compressor?
Tighten fittings where air can be heard escaping. Check fittings with soapy water solution. Do Not Overtighten.
What to do if my DeWalt DCC2560 Air Compressor is too small for the accessory?
Check the accessory air requirement. If it is higher than the CFM or pressure supplied by your air compressor, a larger compressor is needed to operate accessory.
What to do if my DeWalt DCC2560 Air Compressor defective safety valve?
Operate the safety valve manually by pulling on the ring. If the valve still leaks, it must be replaced.
How to tighten tube fittings on DeWalt DCC2560 Air Compressor?
If you hear air escaping from the tube fittings of your DeWalt Air Compressor, tighten the fittings. You can use a soapy water solution to check for leaks, but be careful not to overtighten them.
What to do if my DeWalt DCC2560 motor overload protection switch has tripped?
Refer to Motor Overload Protector under Description of Operations. If the motor overload protection trips frequently, contact a DeWALT factory service center or a DeWALT authorized service center.
Covers risks from sparks, flammable vapors, and overheating, with preventative measures.
Warns against breathing compressed air and highlights risks from sprayed materials.
Details conditions that weaken the air tank, leading to potential explosion.
Emphasizes understanding the manual, keeping area clear, and proper operation for safety.
Details exposure risks to lead and other chemicals from construction activities.
Provides crucial safety warnings for using DEWALT battery chargers and preventing hazards.
Identifies and explains the function of key controls like switches, gauges, and regulators.
Detailed steps for starting, stopping, and safely operating the air compressor.
Lists common problems, their possible causes, and corrective actions for the compressor.
General| Power Source | Battery |
|---|---|
| Max Pressure | 135 PSI |
| Battery Compatibility | 20V MAX |
| Pump Type | Oil-Free |
| Voltage | 20V |
| Type | Cordless |
| SCFM @ 90 PSI | 1.2 SCFM |
To Next Page
