What to do if my DeWalt DCC2560T1 Air Compressor has a defective air tank?
The air tank must be replaced; do not attempt to repair the leak. WARNING: There is a risk of bursting. Do not drill into, weld, or otherwise modify the air tank, as this will weaken it and could cause it to rupture or explode.
Why does my DeWalt DCC2560T1 Air Compressor keep running?
If the pressure switch on your DeWalt Air Compressor doesn't shut off the motor when it reaches the cut-out pressure, set the Auto On/Off switch to "Off" and remove the battery. If it still does not shut off, contact a DeWALT factory service center or a DeWALT authorized service center.
What to do if pump does not run because tank pressure is above cut-in pressure on DeWalt Air Compressor?
If the pump on your DeWalt Air Compressor doesn't run because the tank pressure is above the cut-in pressure, drain the tank until the pressure drops below the cut-in point. The pump should then turn on.
What to do if regulator is damaged on DeWalt DCC2560T1 Air Compressor?
If the regulator on your DeWalt Air Compressor is damaged, it needs to be replaced.
What to do if pump does not run due to safety fault on DeWalt DCC2560T1 Air Compressor?
If the pump on your DeWalt Air Compressor doesn't run due to a safety fault, cycle the Auto On/Off Switch from "Off" to "Auto On."
What to do if tube fittings are not tight enough in my DeWalt Air Compressor?
Tighten fittings where air can be heard escaping. Check fittings with soapy water solution. Do Not Overtighten.
What to do if my DeWalt DCC2560T1 is too small for the accessory?
Check the accessory air requirement. If it is higher than the CFM or pressure supplied by your air compressor, a larger compressor is needed to operate accessory.
What to do if my DeWalt DCC2560T1 defective safety valve?
Operate the safety valve manually by pulling on the ring. If the valve still leaks, it must be replaced.
How to tighten tube fittings on DeWalt Air Compressor?
If you hear air escaping from the tube fittings of your DeWalt Air Compressor, tighten the fittings. You can use a soapy water solution to check for leaks, but be careful not to overtighten them.
What to do if my DeWalt Air Compressor motor overload protection switch has tripped?
Refer to Motor Overload Protector under Description of Operations. If the motor overload protection trips frequently, contact a DeWALT factory service center or a DeWALT authorized service center.
General| Type | Cordless |
|---|---|
| Max Pressure | 135 PSI |
| Battery Compatibility | 20V MAX |
| Power Source | Battery |
| Voltage | 20V |
| Battery Included | Yes |
| Charger Included | Yes |
| Tank Capacity | 2.5 gal |
| CFM at 90 PSI | 0.9 CFM |
To Next Page
