What to do if pump does not run because tank pressure is above cut-in pressure on DeWalt Air Compressor?
If the pump on your DeWalt Air Compressor doesn't run because the tank pressure is above the cut-in pressure, drain the tank until the pressure drops below the cut-in point. The pump should then turn on.
Why does my DeWalt DCC2560T1 Air Compressor keep running?
If the pressure switch on your DeWalt Air Compressor doesn't shut off the motor when it reaches the cut-out pressure, set the Auto On/Off switch to "Off" and remove the battery. If it still does not shut off, contact a DeWALT factory service center or a DeWALT authorized service center.
General| Type | Cordless |
|---|---|
| Max Pressure | 135 PSI |
| Battery Compatibility | 20V MAX |
| Power Source | Battery |
| Voltage | 20V |
| Battery Included | Yes |
| Charger Included | Yes |
| Tank Capacity | 2.5 gal |
| CFM at 90 PSI | 0.9 CFM |
To Next Page
