What to do if DeWalt Air Compressor is not large enough for accessory?
If your DeWalt Air Compressor isn't powerful enough for the accessory you're using, check the accessory's air requirements. If the CFM or pressure needed is higher than what your compressor provides, you'll need a larger compressor.
How to fix air leaks in DeWalt DCC2560T1 Air Compressor?
If you notice air leaks in your DeWalt Air Compressor, the first step is to tighten the fittings to ensure they are properly sealed.
What to do if the safety valve is defective on DeWalt Air Compressor?
If the safety valve on your DeWalt Air Compressor is leaking, try manually operating it by pulling the ring. If the valve continues to leak after that, it needs to be replaced.
What to do if my DeWalt Air Compressor motor overload protection switch has tripped?
Refer to Motor Overload Protector under Description of Operations. If the motor overload protection trips frequently, contact a DeWALT factory service center or a DeWALT authorized service center.
What to do if my DeWalt DCC2560T1 Air Compressor pump won't turn on because tank pressure is too high?
If the pump does not run because the tank pressure is above the cut-in pressure, drain the tank to below the cut-in pressure when the pump turns on.
What to do if my DeWalt Air Compressor is being used excessively?
If your DeWalt Air Compressor experiences prolonged, excessive use of air, decrease the amount of air usage.
What to do if my DeWalt DCC2560T1 pump does not run due to safety fault?
If the pump on your DeWalt Air Compressor does not run due to a safety fault, cycle the Auto On/Off Switch from "Off" to "Auto On."
What to do if pressure switch does not shut off motor when compressor reaches cut-out pressure on DeWalt DCC2560T1?
If the pressure switch on your DeWalt Air Compressor doesn't shut off the motor when it reaches cut-out pressure, set the Auto On/Off switch to "Off" and remove the battery. If it still doesn't shut off, contact a DeWALT factory service center or a DeWALT authorized service center.
What to do if pump does not run due to safety fault on DeWalt DCC2560T1 Air Compressor?
If the pump on your DeWalt Air Compressor doesn't run due to a safety fault, cycle the Auto On/Off Switch from "Off" to "Auto On."
What to do if regulator is damaged on DeWalt DCC2560T1 Air Compressor?
If the regulator on your DeWalt Air Compressor is damaged, it needs to be replaced.
General| Type | Cordless |
|---|---|
| Max Pressure | 135 PSI |
| Battery Compatibility | 20V MAX |
| Power Source | Battery |
| Voltage | 20V |
| Battery Included | Yes |
| Charger Included | Yes |
| Tank Capacity | 2.5 gal |
| CFM at 90 PSI | 0.9 CFM |
To Next Page
