To Next PageTo Next PageWhat to do if pump does not run because tank pressure is above cut-in pressure on DeWalt DCC2560?
If the pump on your DeWalt Air Compressor doesn't run because the tank pressure is above the cut-in pressure, drain the tank until the pressure drops below the cut-in point. The pump should then turn on.
Why does my DeWalt DCC2560 Air Compressor keep running?
If the pressure switch on your DeWalt Air Compressor doesn't shut off the motor when it reaches the cut-out pressure, set the Auto On/Off switch to "Off" and remove the battery. If it still does not shut off, contact a DeWALT factory service center or a DeWALT authorized service center.
General| Power Source | Battery |
|---|---|
| Max Pressure | 135 PSI |
| Battery Compatibility | 20V MAX |
| Pump Type | Oil-Free |
| Voltage | 20V |
| Type | Cordless |
| SCFM @ 90 PSI | 1.2 SCFM |
Covers risks from sparks, flammable vapors, and overheating, with preventative measures.
Warns against breathing compressed air and highlights risks from sprayed materials.
Details conditions that weaken the air tank, leading to potential explosion.
Emphasizes understanding the manual, keeping area clear, and proper operation for safety.
Details exposure risks to lead and other chemicals from construction activities.
Provides crucial safety warnings for using DEWALT battery chargers and preventing hazards.
Identifies and explains the function of key controls like switches, gauges, and regulators.
Detailed steps for starting, stopping, and safely operating the air compressor.
Lists common problems, their possible causes, and corrective actions for the compressor.
