DeWalt DCD700C2-BR - Page 35

ENGLISH
33
IMMEDIATELY, remove drill bit from work, and
determine cause of stalling. DO NOT CLICK TRIGGER ON
AND OFF IN AN ATTEMPT TO START A STALLED DRILL
— THIS CAN DAMAGE THEDRILL.
5. To minimize stalling or breaking through the material,
reduce pressure on drill and ease the bit through the
last fractional part of thehole.
6. Keep the motor running when pulling the bit back out
of a drilled hole. This will help preventjamming.
7. With variable speed drills there is no need to center
punch the point to be drilled. Use a slow speed to start
the hole and accelerate by squeezing the trigger harder
when the hole is deep enough to drill without the bit
skippingout.
Operation as a Screwdriver (Fig. A)
Select the desired speed/torque range using the dual range
gear shifter
5
on the top of tool to match the speed and
torque to the plannedoperation.
Insert the desired fastener accessory into the chuck
6
as
you would any drill bit. Make a few practice runs in scrap or
unseen areas to determine the proper position of the clutch
collar
4
.
MAXIMUM RECOMMENDED CAPACITIES
Low Range ( 1 ) High Range ( 2 )
BITS, METAL DRILLING 1/4" (6.35 mm) 1/8" (3.18 mm)
WOOD, FLAT BORING 3/4" (19.05 mm) 1/2" (12.7 mm)
HOLE SAWS 3/4" (19.05 mm) 5/8" (15.88 mm)
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can causeinjury.
Your DeWALT power tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
tool care and regularcleaning.
Lubrication
Your power tool requires no additionallubrication.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the
risk of eye injury, always wear approved eye protection
when performingthisprocedure.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into aliquid.
Accessories

WARNING: Since accessories, other than those
offered by DeWALT, have not been tested with this
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only DeWALT
recommended accessories should be used with
thisproduct.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
servicecenter.
Repairs
The charger and battery pack are notserviceable.

WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should
be performed by a DeWALT factory service center
or a DeWALT authorized service center. Always use
identical replacementparts.
Protecting the Environment
Separate collection. Products and batteries
marked with this symbol must not be disposed
of with normal householdwaste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to localprovisions.
SPECIFICATIONS
DCD700 12V Max* 0–400 / 0–1500 RPM
DCD710 12V Max* 0–400 / 0–1500 RPM