EasyManuals Logo

DeWalt DCE300M2 User Manual

DeWalt DCE300M2
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
ENGLISH
12
Troubleshooting Guide
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
Problem Possible Cause Possible Solution
Tool does not turn ON when power ON/OFF
switch is pressed.
Battery is not charged. Charge battery or use a new, fully charged battery.
Battery is not fully inserted into tool. Remove battery and reinsert fully into the tool.
Tool does not respond when trigger switch
is pressed.
Battery is too low to complete a crimp/press. Battery
LED lights in red continuously.
Recharge battery in compatible D
e
WALT charger.
Other causes Refer to LED Indications for additional
information.
Tool is plugged into computer via micro
USB cable but the maintenance LED does
not light blue continuously.
Micro USB cable is not the provided cable and may
only be a "charging" cable, not a "data" cable.
Use the provided data cable.
CRIMP CONNECT™ System software is not
working properly.
Other causes View the FAQ page and help screens located
inside the CRIMP CONNECT™ System software.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DeWalt DCE300M2 and is the answer not in the manual?

DeWalt DCE300M2 Specifications

General IconGeneral
BrandDeWalt
ModelDCE300M2
CategoryPower Tool
LanguageEnglish

Related product manuals