ENGLISH
3
EC-Declaration of Conformity
Machinery Directive
Brushless Cordless Compact Impact Driver
DCF787
declares that these products described under
Technical Data are in compliance with:
2006/42/EC, EN62841-1:2015, EN62841-2-2:2014.
These products also comply with Directive 2014/30/EU and
2011/65/EU. For more information, please contact
at
the following address or refer to the back of themanual.
The undersigned is responsible for compilation of the technical
file and makes this declaration on behalf of
.
Markus Rompel
Vice President of Engineering, PTE-Europe
, Richard-Klinger-Straße 11,
D-65510, Idstein, Germany
28.06.2019
WARNING: To reduce the risk of injury, read the
instructionmanual.
Definitions: Safety Guidelines
The definitions below describe the level of severity for each
signal word. Please read the manual and pay attention to
thesesymbols.
DANGER: Indicates an imminently hazardous
situation which, if not avoided, will result in death or
seriousinjury.
WARNING: Indicates a potentially hazardous situation
which, if not avoided, could result in death or
seriousinjury.
CAUTION: Indicates a potentially hazardous situation
which, if not avoided, may result in minor or
moderateinjury.
NOTICE: Indicates a practice not related to
personal injury which, if not avoided, may result in
propertydamage.
Denotes risk of electricshock.
Denotes risk offire.
Congratulations!
You have chosen a
tool. Years of experience, thorough
product development and innovation make
one of the
most reliable partners for professional power toolusers.
Technical Data
DCF787
Voltage V
DC
18
Type 1
Battery type Li-Ion
Power output W 280
No load speed min
-1
0–2800
Impact rate min
-1
0–3200
Max. torque Nm 170
Tool holder 6.35 mm
Weight (without battery pack) kg 0.9
Noise values and/or vibration values (triax vector sum) according to
EN62841-2-2:
L
PA
(emission sound pressure level) dB(A) 89
L
WA
(sound power level) dB(A) 100
K (uncertainty for the given sound level) dB(A) 3
Vibration emission value a
h
= m/s
2
17
Uncertainty K = m/s
2
2.6
The vibration and/or noise emission level given in this
information sheet has been measured in accordance with
a standardised test given in EN62841 and may be used to
compare one tool with another. It may be used for a preliminary
assessment ofexposure.
WARNING: The declared vibration and/or noise emission
level represents impact tightening of fasteners of the
maximum capapcity of the tool. However if the tool is
used for different applications, with different accessories
or poorly maintained, the vibration and/or noise emission
may differ. This may significantly increase the exposure
level over the total workingperiod.
An estimation of the level of exposure to vibration and/
or noise should also take into account the times when the
tool is switched off or when it is running but not actually
doing the job. This may significantly reduce the exposure
level over the total workingperiod.
Identify additional safety measures to protect the
operator from the effects of vibration and/or noise such
as: maintain the tool and the accessories, keep the
hands warm (relevant for vibration), organisation of
workpatterns.
English (original instructions)
BRUSHLESS CORDLESS COMPACT IMPACT DRIVER
DCF787
To Next Page
Loading...
Need help?
General
