DeWalt DCG418 - Specifications

ENGLISH
44
SPECIFICATIONS
DCG418 60V Máx* 9 000 rpm
Repairs
The charger and battery pack are notserviceable.

WARNING: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (including brush
inspection and replacement) should be performed by a
DeWALT
factory service center or a
DeWALT
authorized
service center. Always use identical replacementparts.
Installing the Tool Connect™ Chip
1. Remove the retaining screws
21
that hold the Tool
Connect™ Chip protective cover
22
into thetool.
2. Remove the protective cover and insert the Tool
Connect™ Chip into the empty pocket
23
.
3. Ensure that the Tool Connect™ Chip is flush with the
housing. Secure it with the retaining screws and tighten
thescrews.
4. Refer to Tool Connect™ Chip Instruction Sheet for
furtherinstructions.