DeWalt DCL074 - Important Safety Instructions; General Safety Precautions; Specific Area Light Safety Rules; Battery and Charger Safety

ENGLISH
2
Important Safety
Instructions

WARNING! When using the area
light, basic precautions should always be followed,
including the following:
a ) Read all the instructions before using the arealight.
b ) To reduce the risk of injury, close supervision is
necessary when an area light is used nearchildren.
c ) To reduce the risk of electrical shock, do not put
area light in water or other liquid. Do not place
or store area light where it can fall or be pulled into a
tub orsink.
d ) Only use attachments recommended or sold by
themanufacturer.
e ) Risk of electric shock. Do not expose to rain.
Storeindoors.
f ) To reduce the risk of injury, do not stare at
operating lamp. Serious eye injury couldoccur.
SAVE THESE
INSTRUCTIONS
Specific Safety Rules for Area Lights

WARNING: Fire hazard. Do not operate area light
near flammable liquids or in gaseous or explosive
atmospheres. Internal sparks may ignite fumes
causing personalinjury.
• Do not submerge area light in anyliquid.
• The area light is intended for commercial and
householduse.
• Before using battery and area light/charger, read all
instructions and cautionary markings on area light/
charger and batterypack.
• Store the area light indoors when not in use. Keep out of
reach ofchildren.
• DO NOT attempt to charge the battery pack with any
chargers other than the ones in this manual. The area
light and battery pack are specifically designed to
worktogether.
• Place the area light away from any heatsource.
• Do not disassemble area light. Take it to an authorized
service center when service or repair is required. Incorrect
reassembly may result in a risk of electric shock,
electrocution orfire.
• Secure the area light in upright position whiletransporting.

WARNING: To reduce the risk of fire, do not place
anything on top of the lens during or after operation
of thelight.

WARNING: Do not place the area light in a position
which may cause anyone to intentionally or
unintentionally stare into the area light. Serious eye
injury couldresult.
The label on your light may include the following symbols. The
symbols and their definitions are asfollows:
V ......................... volts
Hz .......................hertz
min ..................... minutes
or DC ......direct current
...................... Class I Construction
(grounded)
…/min ..............per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
A ......................... amperes
W ........................watts
or AC ...........alternating current
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n
o
.......................no load speed
n .........................rated speed
......................earthing terminal
.....................safety alert symbol
.....................visible radiation
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
.....................hot surface
..................... on/off button
..................... pinch/crush hazard
Important Safety Instructions for the
Area Light

WARNING: Read all safety warnings and all
instructions for the battery pack and area light.
Failure to follow the warnings and instructions
may result in electric shock, fire and/or
seriousinjury.
• The area light is intended for workspace lighting
only. Use as directed. Any other uses may result in risk of
fire, electric shock orelectrocution.
• Do not expose the area light to rain orsnow.
• When operating the area light outdoors, always
provide a drylocation.
BATTERIES AND CHARGERS
The battery pack is not fully charged out of the carton.
Before using the battery pack and charger, read the
safety instructions below and then follow charging
proceduresoutlined. When ordering replacement battery
packs, be sure to include the catalog number andvoltage.
Your tool uses a
DeWALT
charger. Be sure to read all safety
instructions before using your charger. Consult the chart
at the end of this manual for compatibility of chargers and
batterypacks.
READ ALL INSTRUCTIONS
Important Safety Instructions for All
Battery Packs

WARNING: Read all safety warnings and all
instructions for the battery pack, charger and
power tool. Failure to follow the warnings and
instructions may result in electric shock, fire and/
or serious injury.
• Do not charge or use the battery pack in explosive
atmospheres, such as in the presence of flammable