EasyManuals Logo

DeWalt DCL079 Manual

DeWalt DCL079
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
8
ENGLISH
to the lowest brightness. Pressing the power button a fourth
time will turn the lightoff.
3. Pivot the light head as needed using the light head'sframe.
4. When finished using the tripod light, press the power
button until the light turnsoff.
WARNING: Burn hazard. The light head's heatsink
15
(Fig. D) becomes hot during use. Do not touch heatsink
when worklight is on or immediately after use, and keep
away from combustible materials. Always pivot the head
using only the head'sframe.
Low Battery Indicator
As the battery nears a fully discharged state, the light will blink
twice and then dim, dropping the brightness of the light below
the normal level. The light will continue to blink twice every
45 seconds until the battery is fully discharged at which time
the light will turn off. Indication time will vary based on battery
packcapacity.
WARNING: Stop work and replace the battery when this
occurs. To reduce the risk of injury, always have a back-up
battery or secondary lighting available if the situation
warrantsit.
MAINTENANCE
Your DeWALT power tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regularcleaning.
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can causeinjury.
The charger and battery pack are notserviceable.
The light source contained in this light shall only be replaced
by the manufacturer or its service agent or a similarly
qualifiedperson.
Lubrication
Your power tool requires no additionallubrication.
Cleaning
WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing thisprocedure.
WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into aliquid.
Optional Accessories
WARNING: Since accessories, other than those offered
by DeWALT, have not been tested with this product, use
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only
DeWALT recommended
accessories should be used with thisproduct.
Consult your dealer for further information on the
appropriateaccessories.
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
householdwaste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails
to produce sufficient power on jobs which were easily done
before. At the end of its technical life, discard it with due care for
our environment:
Run the battery pack down completely, then remove it from
thetool.
Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed ofproperly.

Other manuals for DeWalt DCL079

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DeWalt DCL079 and is the answer not in the manual?

DeWalt DCL079 Specifications

General IconGeneral
BrandDeWalt
ModelDCL079
CategoryWork Light
LanguageEnglish

Related product manuals