DeWalt DCL183 - Definitions: Safety Guidelines; Safety Instructions; Additional Safety Warnings

11
ENGLISH
SAFETY INSTRUCTIONS
When using an electrical light, basic precautions should always be
followed, including the following:

WARNING: Do not attempt to modify or repair thelight.

WARNING: Do not charge the battery at ambient
temperatures below 4°C (40°F) or above 40°C
(104°F). Follow all charging instructions and do not
charge the battery outside of the temperature range
specified in the instructions. Charging improperly or at
temperatures outside of the specified range may damage
the battery and increase risk offire.
• Shock Hazard. To protect against risk of electrical shock, do
not put charging base in water or otherliquid.
• Do not allow to be used as a toy. Close attention is
necessary when used nearchildren.
• Do not use if damaged. If light is not working as it should,
has been dropped, damaged, left outdoors, or dropped into
water, return it to a servicecenter.
• Do not incinerate the light even if it is severely damaged.
The batteries can explode in afire.
• Do not pull or carry by charging cord, use charging
cord as a handle, close a door on charging cord, or pull
charging cord around sharp edges or corners.
• Keep charging cord away from heatedsurfaces.
• Do not allow the cord to hang over the edge of a table or
counter or touch hot surfaces. The unit should be placed or
mounted away from sinks and hotsurfaces.
• Do not unplug by pulling on charging cord. To unplug,
grasp the plug, not thecord.
• Do not handle charging cord, including charging plug
with wethands.
• Do not charge the unitoutdoors.
• Leaks from battery cells can occur under extreme
conditions. If the liquid, which is a 20-35% solution of
potassium hydroxide, gets on the skin (1) wash quickly with
soap and water or (2) neutralize with a mild acid such as
lemon juice or vinegar. If the liquid gets into the eyes, flush
them immediately with clean water for a minimum of 10
minutes. Seek medicalattention.
Additional Safety Warnings
a ) This light is intended for professional, commercial or
industrialuse.
b ) Do not use a battery or light that is damaged or modified.
Damaged or modified batteries may exhibit unpredictable
behavior resulting in fire, explosion or risk ofinjury.
c ) Do not expose a battery to fire or excessive
temperature. Exposure to fire or temperature above
130°C (266°F) may causeexplosion.
d ) Do not use magnet for overhead mounting.
e ) The luminaire should be powered by certified power supply
with SELV output (constant voltage 5 Vdc).
SAVE THESE INSTRUCTIONS
WARNING: To reduce the risk of injury, read the
instructionmanual.
Definitions: Safety Guidelines
The definitions below describe the level of severity for each
signal word. Please read the manual and pay attention to
thesesymbols.

DANGER: Indicates an imminently hazardous
situation which, if not avoided, will result in death or
seriousinjury.

WARNING: Indicates a potentially hazardous situation
which, if not avoided, could result in death or
seriousinjury.

CAUTION: Indicates a potentially hazardous situation
which, if not avoided, may result in minor or
moderateinjury.
NOTICE: Indicates a practice not related to
personal injury which, if not avoided, may result in
propertydamage.

Denotes risk of electricshock.

Denotes risk offire.
DCL183
Voltage V
DC
3.6
Type 1
Lumens
Spot light LED lm
Low - 250
High - 1000
Side light LED lm 400
Light Beam Angle
Spot light LED degrees 15
Side light LED degrees 90
Run Time When Fully Charged
Spot light LED hours
Low - 6.5
High - 2.5
Side light LED hours 6.5
Congratulations!
You have chosen a DeWALT tool. Years of experience, thorough
product development and innovation make DeWALT one of the
most reliable partners for professional power toolusers.
Technical Data
English (original instructions)
RECHARGEABLE LED FLASHLIGHT
DCL183