DeWalt DCL183 - Protecting the Environment; Maintenance

14
ENGLISH
Protecting the Environment
Separate collection. Products marked with this symbol
comply with the European Directive 2012/19/EU
and must not be disposed of with normal household
waste; Products contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products according to local provisions.
Further information is available at www.2helpU.com.
Accessories

WARNING: Since accessories, other than those offered
by DeWALT, have not been tested with this product, use
of such accessories with this product could be hazardous.
To reduce the risk of injury, only DeWALT recommended
accessories should be used with thisproduct.
There are no accessories for this product.
Cleaning

WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the lamp. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the lamp; never immerse any
part of the lamp into aliquid.
MAINTENANCE
Your DeWALTproduct has been designed to operate over a long
period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper care and
regularcleaning.
Magnet (Fig.A)

CAUTION: When the LED light hangs by the magnet,
do not shake the LED light or the object from which it
hangs. Do not hang the work LED light overhead or from
anything that is not secure. Personal injury or property
damage may occur.

CAUTION: Only use the magnet for hanging the LED light.
The magnet is not intended to support additional weight. Do
not attach or hang anything additional to the LED light or risk
of breakage may occur.
1. The DCL183 has a magnet
4
built into the bottom of the light.
2. The magnet
4
is intended for catching small metal parts
such as screws and bolts or to hold the light in place on
solid metal surfaces.
4. Press the multi function button
1
a fourth time to turn off
the side LED
5
.
Hang Hook (Fig.A, D)

CAUTION: When the LED light hangs by the hang hook,
do not shake the LED light or the object from which it
hangs. Do not hang the LED light overhead or from any
electrical wires or anything that is not secure. Personal
injury or property damage may occur.

CAUTION: Only use the hang hook for hanging the LED
light. The hang hook is not intended to support additional
weight. Do not attach or hang anything additional to the
LED light or risk of breakage may occur.

CAUTION: Do not use the hang hook to reach with or to
support your weight in any situation.
The built in hang hook
7
can be be attached to anchored
hoses, pipes, tubes or cables in the space you are working in.
1. To access the hang hook
7
, rotate thehanghook
7
 away
from the housing
2
until the hang hook opening
14
isexposed.
2. Place the hose, pipe, tube or cable in your work space into the
hang hook.
NOTE: Ensure the LED light housing is fully secured and will
not slide off or along the anchored hose, pipe, tube or cable
beforeproceeding.
3. To remove the hang hook
7
from the anchored hose,
pipe, tube or cable, grasp the hang hook
7
and slide the
anchored hose, pipe, tube or cable from the hang hook
opening
14
.
4. Secure the hang hook
7
into place onto the housing
2
.