DeWalt DCL510 - Intended Use and Electrical Safety; Product Usage Guidelines; Electrical Safety and Extension Cables

English
17
INTENDED USE
These worklights are professional tools.
DO NOT use under wet conditions or in presence of flammable liquids
or gases.
DO NOT let children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.
 • Thisproductisnotintendedforusebypersons(includingchildren)
suffering from diminished physical, sensory or mental abilities,
or for lack of experience and/or for want of knowledge or skills
unless they are supervised by a person responsible for their safety.
Children should never be left alone to play with this product.
Electrical Safety
The product has been designed for one voltage only. Always check that
the battery pack voltage corresponds to the voltage on the rating plate.
Also make sure that the voltage of your charger corresponds to that of
your mains.
Your DeWALT charger is double insulated in accordance with
IEC 60335; therefore no earth wire is required.
If the supply cord is damaged, it must be replaced by a specially
prepared cord available through the DeWALT service organisation.
Using an Extension Cable
An extension cord should not be used unless absolutely necessary.
Use an approved extension cable suitable for the power input of your
charger (see Technical Data). The minimum conductor size is 1 mm
2
;
the maximum length is 30 m.
When using a cable reel, always unwind the cable completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: Use only DeWALT battery packs and chargers.