DeWalt DCL510 - Service and Worklight Safety; Tool Servicing; Worklight Handling Safety; Tool Markings and Date Code

English
7
SERVICE
a) Have your tool serviced by a qualified repair person using
only identical replacement parts. This will ensure that the
safety of the power tool is maintained.
Additional Specific Safety Rules for Worklights
WARNING: Fire hazard. Do not operate worklight or
charger near flammable liquids or in gaseous or explosive
atmospheres. Internal sparks may ignite fumes causing
personal injury.
 • Donotexposelightorchargertowetordampareas.Donot
expose light or charger to rain or snow.
 • Donotwashlightorchargerwithwaterorallowwatertogetinside
light or charger. Do not submerge light in water at any time.
 • Donotoperatewithoutlenscoverassemblyattached.
CAUTION: When not in use, place tool on its side on
a stable surface where it will not cause a tripping
or falling hazard. Some tools with large battery packs
will stand upright on the battery pack but may be easily
knocked over.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Do not stare directly into the light source.
DATE CODE POSITION
The date code, which also includes the year of manufacture, is printed
into the housing surface that forms the mounting joint between tool and
battery.