ENGLISH
45
Package Contents
The package contains:
1 Nailer
1 Charger (M2 models only)
2 Battery packs (M2 models only)
1 Non-mar tip
1 Kitbox (M2 models only)
1 Instruction manual
1 Exploded drawing
NOTE: Battery packs, chargers, and kit boxes are
not included with N-models.
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1, 2)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Trigger
b. Trigger safety lock-off
c. Contact trip
d. Depth adjustment wheel
e. Low battery and jam/stall indicator light
f. Stall release lever
g. Magazine
h. Pusher latch
i. Mode selector switch
j. Rotating rafter/belt hook
k. On-board hex wrench
l. Battery pack
m. Non-mar tip
INTENDED USE
The DCN690 cordless framing nailer has been
designed for driving nails into wooden workpieces.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
These cordless nailers are professional power tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.
Electrical Safety
The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your DEWALT charger is double insulated
in accordance with EN 60335; therefore
no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
DEWALT service organisation.
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see Technical Data). The minimum conductor size
is 1 mm
2
; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
To Next Page
Loading...
