DeWalt DCS355 User Manual

48
ENGLISH
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Unit will not
start.
Battery not
installed
correctly.
Install battery in tool handle and ensure it is seated correctly.
Battery is not
charged.
Place battery on charger and install a fully charged battery pack in
tool.
Battery or
power tool is
overheated.
Allow battery and/or tool to cool after extended use or replace
overheated battery pack with a cool one.
Switch is
damaged.
Have switch replaced by an authorised DEWALT repair agent.

DeWalt DCS355 Specifications

General

Voltage	20V MAX
Oscillations per Minute	0-20, 000 OPM
Tool-Free Accessory Change	Yes
Variable Speed Control	Yes
Power Source	Battery
Oscillation Angle	1.6 degrees
Battery Type	Lithium-Ion