DeWalt DCS355 User Manual

42
ENGLISH
Electrical Safety
The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your DEWALT charger is double insulated
in accordance with EN 60335; therefore
no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
DEWALT service organisation.
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see Technical Data). The minimum conductor size
is 1 mm
2
; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: Prior to assembly and
adjustment, always remove the
battery pack. Always switch off the
tool before inserting or removing
the battery pack. Be sure the trigger
switch is in the OFF position. An
accidental start-up can cause injury.
WARNING: Risk of lacerations or
burns. Do not touch the sharp
edges of accessories at any time.
Do not touch workpiece or blade
immediately after operating the tool.
They can become very hot. Handle
carefully. Always allow accessories and
workpiece to cool before handling.
25 Assorted sandpaper pieces**
1 9.5mm x 43mm Wood detail blade**
1 3mm Carbide grout removal blade**
(100mm half moon)
1 Cutting guide hex key**
1 Charger**
2 Li-Ion battery packs**
1 TStak kitbox**
NOTE: Battery packs, chargers and kitboxes are not
included with N-models.
• Check for damage to the tool, parts or
accessories which may have occurred
during transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1, 2)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Variable speed trigger
b. LED Worklight
c. Accessory clamp lever
d. Lock on/off button
e. Accessory side mount slots
f. Cut guide block
g. Cut guide arm
h. Battery pack
i. Battery release button
j. Fuel gauge button
INTENDED USE
This oscillating multi-tool is designed for professional
detail sanding, plunge cutting, flush cutting, removal
of excess materials and surface preparation
applications.
DO NOT use under wet conditions or in the
presence of flammable liquids or gases.
This oscillating multi-tool is a professional power
tool.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.

DeWalt DCS355 Specifications

General

Voltage	20V MAX
Oscillations per Minute	0-20, 000 OPM
Tool-Free Accessory Change	Yes
Variable Speed Control	Yes
Power Source	Battery
Oscillation Angle	1.6 degrees
Battery Type	Lithium-Ion