DeWalt DCS371 Original Instructions

ENGLISH
45
recommended. End pieces may be hot and
sharp.
7. Whenever possible, hold the saw firmly in both
hands. If an application requires only one hand
to be placed on the saw, be sure to keep the
second hand clear of the blade area and do
not allow the saw to fall against the clamped or
supported material when the cut is complete.
Tips for Better Cutting
The following recommendations should be used
as a guide (refer to the Recommended Cutting
Positions chart). Results may vary with the operator
and the particular material being cut.
• Never twist the band saw blade during cutting
operation.
• Never use liquid coolants with portable band
saws. Use of liquid coolants will cause build-up
on tyres and reduce performance.
• If excessive vibration occurs during the cut,
ensure that the material being cut is securely
clamped down. If vibration continues, change
the band saw blade.
RECOMMENDED CUTTING POSITIONS
yes
no yes no
yes
no yes no
yes
no yes no
MAINTENANCE
Your DEWALT power tool has been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
The charger and battery pack are not serviceable.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect
the charger from the AC outlet before
cleaning. Dirt and grease may be
removed from the exterior of the charger
using a cloth or soft non-metallic brush.
Do not use water or any cleaning
solutions.
Optional Accessories
WARNING: Since accessories, other
than those offered by DEWALT, have
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only DEWALT recommended
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.

DeWalt DCS371 Specifications

General

Product color	Black, Yellow
Built-in light	No
Adjustable speed	-
Blade width	12 mm
Blade length	835 mm
Blade thickness	0.5 mm
Saw blade included	Yes
Input power	460 W
Power source	Battery
Battery voltage	18 V

Weight and Dimensions

Width	385 mm
Height	280 mm
Weight	3900 g