6
ENGLISH
WARNING: To reduce the risk of injury, read the
instructionmanual.
Definitions: Safety Guidelines
The definitions below describe the level of severity for each
signal word. Please read the manual and pay attention to
thesesymbols.
DANGER: Indicates an imminently hazardous
situation which, if not avoided, will result in death or
seriousinjury.
WARNING: Indicates a potentially hazardous situation
which, if not avoided, could result in death or
seriousinjury.
CAUTION: Indicates a potentially hazardous situation
which, if not avoided, may result in minor or
moderateinjury.
NOTICE: Indicates a practice not related to
personal injury which, if not avoided, may result in
propertydamage.
Denotes risk of electricshock.
Denotes risk offire.
EC‑Declaration of Conformity
Machinery Directive
Cordless Circular Saw
DCS577
declares that these products described under
Technical Data are in compliance with:
2006/42/EC, EN62841‑2‑1:2015, EN62841‑2‑5:2014.
These products also comply with Directive 2014/30/EU and
2011/65/EU. For more information, please contact
at
the following address or refer to the back of themanual.
The undersigned is responsible for compilation of the technical
file and makes this declaration on behalf of
.
Markus Rompel
Vice‑President Engineering, PTE‑Europe
, Richard‑Klinger‑Straße 11,
D‑65510, Idstein, Germany
14.10.2019
The vibration and/or noise emission level given in this
information sheet has been measured in accordance with
a standardised test given in EN62841and may be used to
compare one tool with another. It may be used for a preliminary
assessment ofexposure.
WARNING: The declared vibration and/or noise emission
level represents the main applications of the tool. However
if the tool is used for different applications, with different
accessories or poorly maintained, the vibration and/or
noise emission may differ. This may significantly increase
the exposure level over the total workingperiod.
An estimation of the level of exposure to vibration and/or
noise should also take into account the times when the tool
is switched off or when it is running but not actually doing
the job. This may significantly reduce the exposure level
over the total workingperiod.
Identify additional safety measures to protect the operator
from the effects of vibration and/or noise such as: maintain
the tool and the accessories, keep the hands warm
(relevant for vibration), organisation of workpatterns.
DCS577
Voltage V
DC
54
Type 2
Battery type Li‑Ion
Blade diameter mm 190
No load/Rated Speed min‑1 5800
Bevel angle adjustment degree 53
Maximum depth of cut mm 65
Weight (without battery pack) kg 5.0
Noise values and/or vibration values (triax vector sum) according to
EN62841‑2‑5:
L
PA
(emission sound pressure level) dB(A) 94
L
WA
(sound power level) dB(A) 105
K (uncertainty for the given sound level) dB(A) 3
Vibration emission value a
h,W
= m/s
2
<2.5
Uncertainty K = m/s
2
1,5
Congratulations!
You have chosen a
tool. Years of experience, thorough
product development and innovation make
one of the
most reliable partners for professional power toolusers.
Technical Data
English (original instructions)
CORDLESS HI‑TORQUE CIRCULAR SAW
DCS577
To Next Page
Loading...
Need help?
General
