ENGLISH
17
CHARGER
DE9116/DE9117/DE9130/DE9216
Congratulations!
You have chosen a DEWALT product. Years of experience, thorough product development and innovation
make D
EWALT one of the most reliable partners for professional users.
Technical data
DE9116 DE9117 DE9130 DE9216
Mains voltage V
AC
230 230 230 230
(U.K. & Ireland only) V 230 230 230 230/115
Output V
DC
7.2–18 7.2–18 7.2–18 7.2–18
Charge current
normal mode A 2.8 8.3 5.0 2.8
equalise mode mA 150 150 150 150
maintenance mode mA 63 63 63 63
Charging time
2.4 Ah NiCd packs min 70 30 35 70
2.0 Ah NiCd packs min 60 15 30 60
1.3 Ah NiCd packs min 30 15 15 30
3.0 Ah NiMH packs min 90 50 – 90
2.6 Ah NiMH packs min 75 35 40 75
Weight kg 0.4 0.9 0.5 0.4
Fuses:
Europe 230 V tools 10 Amperes, mains
U.K. & Ireland 230 V tools 13 Amperes, in plugs
U.K. & Ireland 115 V tools 16 Amperes, mains
Defi nitions: Safety Guidelines
The definitions below describe the level of severity
for each signal word. Please read the manual and
pay attention to these symbols.
DANGER: Indicates an imminently
hazardous situation which, if not
avoided, will result in death or serious
injury.
WARNING: Indicates a potentially
hazardous situation which, if not
avoided, could result in death or
serious injury.
CAUTION: Indicates a potentially
hazardous situation which, if not
avoided, may result in minor or
moderate injury.
CAUTION: Used without the safety alert
symbol indicates a potentially hazardous
situation which, if not avoided, may
result in property damage.
Denotes risk of electric shock.
Denotes risk of fire.
EC-Declaration of Conformity
DE9116/DE9117/DE9130/DE9216
DEWALT declares that these products described
under “technical data” have been designed in
compliance with: 89/336/EEC, 2006/95/EC,
EN 60335, 2002/95/EC, EN 55014-1, EN 50014-2,
EN 61000-3-2, EN 61000-3-3.
This unit must not be put into service until it was
established that the power tool to be connected to
this unit is in compliance with 98/37/EC (identified by
the CE-marking on the power tool).
For more information, please contact DEWALT at the
following address or refer to the back of the manual.
The undersigned is responsible for compilation of the
technical file and makes this declaration on behalf of
DEWALT.
To Next Page
Loading...
