DeWalt DW325C - Specifications; Components (Fig. 1)

WARNING: Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities contains chemicals
known to the State of California to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
• leadfromlead-basedpaints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenicandchromiumfromchemically-treatedlumber.
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
WARNING: ALWAYS USE SAFETY GLASSES. Everyday
eyeglassesareNOTsafetyglasses.Alsousefaceordustmask
if operation is dusty. ALWAYS WEAR CERTIFIED SAFETY
EQUIPMENT:
• ANSIZ87.1eyeprotection(CAN/CSA/Z94.3),
• ANSIS12.6(S3.19)hearingprotection,
• NIOSH/OSHA/MSHArespiratoryprotection.
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE
Specications
MODEL DW325C
HEIGHT 13-1/4" (336 mm)
WIDTH 5-9/16" (140 mm)
LENGTH 12-1/16" (306 mm)
WEIGHT 8 lbs 8 oz (3.86 kg)
OPERATING PRESSURE 70 – 120 psig (4.9 – 8.43kg/cm
2
)
AIR CONSUMPTION PER 100
CYCLES *
7.8 cfm (.093 m
3
) @
80 psi (5.62 kg/cm
2
)
LOADING CAPACITY Up to 300–350 Nails
FASTENER LENGTHS 1-1/2" – 3-1/4"
(38.1 – 82.6mm)
SHANK DIAMETER 0.099" – .131" (2.5 – 3.3mm)
FASTENER COLLATION 15° wire weld
*Take the actual rate at which the tool will be run to determine the
amount of air required. For instance, if your fastener usage averages
50 nails per minute, you need 50% of the 7.8 c.f.m. which is
required for running at 100 nails per minute.
COMPONENTS (FIG. 1)
A. Trigger
B. Exhaust deflector
C. No-Mar pad
D. Contact trip
E. Magazine latch
F. Magazine
English
5