DeWalt DW621

21
ENGLISH
• For slotter cutters, the maximum shank diameter
MUST be 8mm and the maximum diameter MUST
be 25mm.
• For grooved knives, the maximum shank diameter
MUST be 8mm, the maximum diameter MUST
be 40mm and the maximum cutting width MUST
be4mm.

WARNING: We recommend the use of a residual current
device with a residual current rating of 30mA orless.
Residual Risks
In spite of the application of the relevant safety regulations
and the implementation of safety devices, certain residual risks
cannot be avoided. These are:
• Impairment ofhearing.
• Risk of personal injury due to flyingparticles.
• Risk of burns due to accessories becoming hot
duringoperation.
• Risk of personal injury due to prolongeduse.
Electrical Safety
The electric motor has been designed for one voltage only.
Always check that the power supply corresponds to the voltage
on the ratingplate.
Your DeWALT tool is double insulated in accordance
with EN62841; therefore no earth wire isrequired.

WARNING: 115V units have to be operated via a fail‑safe
isolating transformer with an earth screen between the
primary and secondarywinding.
If the supply cord is damaged, it must be replaced by a
specially prepared cord available through the
DeWALT
serviceorganisation.
Mains Plug Replacement
(U.K.& Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the oldplug.
• Connect the brown lead to the live terminal in theplug.
• Connect the blue lead to the neutralterminal.

WARNING: No connection is to be made to the
earthterminal.
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 13A.
Using an Extension Cable
If an extension cable is required, use an approved 3–core
extension cable suitable for the power input of this tool (see
Technical Data).The minimum conductor size is 1.5 mm
2
; the
maximum length is 30m.
When using a cable reel, always unwind the cablecompletely.
Package Contents
The package contains:
1 Router
1 Parallel fence with fine adjustment and guiderods
1 Collet 1/4" (DW621-XE)
1 Collet 1/2" (DW621-XE)
1 Collet 8mm (DW621 QS)
1 Collet 12mm (DW622 QS)
1 Guide bush 24mm
1 Wrench # 17(DW621 QS)
1 Wrench # 22(DW621-XE, DW622 QS)
1 Dust extraction plug
1 Instruction manual
• Check for damage to the tool, parts or accessories which may
have occurred duringtransport.
• Take the time to thoroughly read and understand this manual
prior tooperation.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual beforeuse.
Date Code Position (Fig.A)
The date code
31
, which also includes the year of manufacture,
is printed into thehousing.
Example:
2021XX XX
Year of Manufacture
Description (Fig.A)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury couldresult.
1
Lock-off switch
2
Spindle lock
3
Collet nut
4
Parallel fence locking bolt
5
Guide rods for parallel fence
6
Dust extraction outlet in parallel fence
7
Fine adjuster for parallel fence
8
Parallel fence
9
Locking bolt
10
Router base
11
Finger guard
12
Revolver depth stop
13
Depth stop
14
Depth stop locking bolt
15
Plunge limiter
16
Quick adjuster for depth stop
17
Fine adjuster for depth stop
18
Dust extraction adaptor
19
Speed control dial
20
End lock