What to do if my DeWalt DW746 Saw will not start?
If your DeWalt Saw won't start, first ensure it is properly plugged in. If it still fails to start, try replacing the fuse or resetting the circuit breaker. If these steps don't resolve the issue, the cord may need to be replaced by an authorized service center.
What to do if DeWalt DW746 Saw blade does not come up to speed?
If your DeWalt Saw blade does not come up to speed, replace the cord with an adequate size cord. For further assistance, contact your electric power company or replace the belt.
How to correct inaccurate miter cuts on DeWalt DW746 Saw?
To address inaccurate miter cuts on your DeWalt Saw, check and adjust the settings. Also, check and adjust the bevel stops. Another solution is to clamp the workpiece to the miter head face, gluing 120 grit sandpaper to the miter head face.
What to do if material binding during cut with DeWalt DW746 Saw?
If the material binds during a cut with your DeWalt Saw, ensure the material is laid flat at the point of cut and supported with scrap and/or a miter gauge. You may also need to align the fence or align the splitter.
How to fix DeWalt Saw fence that does not slide freely?
If your DeWalt Saw's fence does not slide freely, clean the front and rear rails and reapply wax. Additionally, adjust the rear cap position.
What to do if the rear of the fence pops up when fence locks on DeWalt Saw?
If the rear of the fence pops up when the fence locks on your DeWalt Saw, re-attach the fence, ensuring the clip is engaged. You may also need to adjust the rear cap position.
Importance of grounding for safety and proper connection of equipment.
Guidance on how to prevent and protect yourself from kickback incidents.
Steps for assembling the bevel crank and front/rear fence rails.
Instructions for assembling the fence beam and adjusting the fence alignment.
Steps for installing the blade guard, splitter, and throat plate for safe operation.
How to adjust bevel stops, scale, and miter gauge for precise cuts.
Instructions for the on-off switch and guidelines for selecting appropriate saw blades.
Detailed instructions for ripping, crosscutting, and handling small pieces safely.
Solutions for common problems like saw not starting, making poor cuts, or blade speed issues.
Troubleshooting for inaccurate cuts, fence alignment, and sliding issues.
General| Type | Table Saw |
|---|---|
| Blade Diameter | 10 inches |
| Max Rip to Right of Blade | 30 inches |
| Max Rip to Left of Blade | 12 inches |
| Max Depth of Cut at 90 Degrees | 3-1/8 inches |
| Max Depth of Cut at 45 Degrees | 2-1/4 inches |
| Voltage | 120V |
| Table Material | Cast Iron |
| Arbor Size | 5/8 inches |
| Amperage | 15 Amp |
| Rip Capacity | 30 inches |
To Next Page
