5
English
Fence Angle Adjustment
Angle adjustment indicator is part of fence clamping system. Align
desired angle indicator line with edge of slot in base (see Figure 7).
For a more accurate square cut (Figure 7), disconnect power supply,
unlock fence, push arm down until wheel extends into base, place a
square against wheel, adjust fence against square, then lock fence
into position.
Switch
To start the tool, depress the trigger switch shown in Figure 8. To turn
the tool off, release the trigger switch. Keep hands and material from
wheel until it has coasted to a stop.
TRIGGER SWITCH
FIG. 8
SPINDLE SHAFT
FLANGE,
INSIDE
FLAT
WASHER
FLANGE,
OUTSIDE
WHEEL
FIG. 10
M10
BOLT
INTERNAL
THREAD
Removal and Installation of Wheels
1. Be sure tool is disconnected from power supply.
2. Push in wheel lock lever (Figure 9) and rotate wheel by hand until
wheel lock lever engages slot in inside flange to lock wheel.
Loosen the bolt counterclockwise in the center of the abrasive
wheel with the 8 mm hex wrench found in the holder in the base.
Bolt has right hand thread.
3. Remove the bolt, washer, outside flange, and old wheel (Fig. 10).
4. Install the new abrasive wheel by reversing the above steps.
5. Do not over tighten bolt.
DO NOT MAKE ANY ADJUSTMENT WHILE THE WHEEL IS IN MOTION.
DO NOT MAKE ANY ADJUSTMENT WHILE CHOP SAW IS PLUGGED
INTO POWER SUPPLY.
WARNING: CHECK THE WORK SURFACE THAT THE CHOP
SAW RESTS ON WHEN REPLACING WITH A NEW ABRASIVE
WHEEL. IT IS POSSIBLE THAT THE WHEEL MAY CONTACT ANY
ITEMS OR STRUCTURE THAT EXTENDS ABOVE WORK SURFACE
(UNDER THE BASE) WHEN THE ARM IS FULLY LOWERED.
WHEEL
FIG. 7
SQUARE
FIG. 9
WHEEL LOCK LEVER
ANGLE
ADJUSTMENT
INDICATOR
SLOT EDGE
To Next Page
Loading...
