6
English
NAIL
FIG. 12
Mounting
PROCEDURE FOR PERMANENT MOUNTING
1. Drill four holes 5/16" through the work surface. (Figure 11)
2. Insert 1/4-20 screws down through the holes in the base and
through holes in mounting surface. The approximant length of
the screws should be the thickness of the mounting surface plus
4 inches.
CRADLE MOUNTING
1. Cut two boards approximately 20" long x 2" high x 4" wide.
2. Place chop saw at desired work location.
3. Place boards tightly along side, and nail to work surface,
(Figure 12).
17-3/8"
(441 MM)
10-1/8"
(257 MM)
FIG. 11
Motor Brush Inspection and
Replacement
Be sure tool is unplugged before inspecting brushes. Brushes should
be regularly inspected for wear. To inspect brushes, unscrew the
two end cap screws and remove end cap (see Figure 13). To remove
each brush, first unplug the shunt wire terminal connection. Then
carefully back the brush spring out of the brush box and remove
brush (see Figure 13). Brushes should slide freely in brush box. If
brushes are worn down to .3” (see Figure 14) they should be
replaced. To reinstall each brush carefully back the spring out of the
brush box, insert the brush and return the spring making sure it is
pressing on the brush and not touching the brush box. Then replace
the end cap and two screws.
.3"
(8 MM)
BRUSH
FIG. 14
FIG. 13
SCREWS
END CAP
BRUSH
SPRING
To Next Page
Loading...
