DeWalt DWD014 - Electrical Safety; Assembly and Adjustments

7
ENGLISH
Forward/Reverse Lever (Fig.A)
The forward/reverse lever
3
is used for withdrawing bits
from tight holes and removing screws. It is located above the
triggerswitch.
To reverse the motor, release the trigger switch FIRST and then
push the lever to the right (viewed when holding the drill in the
operatingposition).
After any reversing operations, return lever to forwardposition.
Description (Fig.A)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury couldresult.
1
Variable speed trigger switch
2
Lock-on button
3
Forward/reverse lever
4
Chuck
5
Cord protector
6
Cord set
7
Speed dial (DWD014S, DWD014S-XE)
8
Main handle
9
Date code position
Intended Use
These heavy-duty V.S.R. drills are designed for
professionaldrilling.
DO NOT use under wet conditions or in the presence of
flammable liquids orgases.
These heavy-duty drills are professional powertools.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
thistool.
• Young children and the infirm. This appliance is not
intended for use by young children or infirm persons
withoutsupervision.
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their
safety. Children should never be left alone with thisproduct.
Example:
2021XX XX
Year and Week of Manufacture
Date Code Position (Fig.A)
The date code
9
, which also includes the year of manufacture,
is printed into thehousing.
Markings on Tool
The following pictograms are shown on the tool:
a
Read instruction manual beforeuse.
g
Wear earprotection.
f
Wear eyeprotection.
Package Contents
The package contains:
1 Drill
1 Chuck key (DWD014)
1 Instruction manual
DeWALT
• Check for damage to the tool, parts or accessories which may
have occurred duringtransport.
• Take the time to thoroughly read and understand this manual
prior tooperation.
Electrical Safety
The electric motor has been designed for one voltage only.
Always check that the power supply corresponds to the voltage
on the ratingplate.
Your DeWALT tool is double insulated in accordance
with EN62841; therefore no earth wire isrequired.
This product is intended to be used with a safety transformer
manufactured to BSEN61558 and BS4343. Never work without
this transformer inplace.
If the supply cord is damaged, it must be replaced only by
DeWALT or an authorised serviceorganisation.
Mains Plug Replacement
(U.K.& Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the oldplug.
• Connect the brown lead t o the live terminal in theplug.
• Connect the blue lead to the neutralterminal.

WARNING: No connection is to be made to the
earthterminal.
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 13A.
Using an Extension Cable
If an extension cable is required, use an approved 3–core
extension cable suitable for the power input of this tool (see
Technical Data).The minimum conductor size is 1.5 mm
2
; the
maximum length is 30 m.
When using a cable reel, always unwind the cablecompletely.
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. An accidental
start‑up can causeinjury.