DeWalt DWE4010-BR - Page 27

ENGLISH
25
Fig. D
14
13
12
11
10
4. Screw the threaded clamp nut
14
onto the spindle
11
a. The ring on the threaded clamp nut
14
must face
towards the disc when fitting a grinding disc (Fig. E1);
b. The ring on the threaded clamp nut
14
must
face away from the disc when fitting a cutting
disc(Fig.E2).
5. Press the spindle lock
2
and rotate the spindle
11
until
it locks inposition.
6. Tighten the threaded clamp nut
14
with the two-pin
spannersupplied.
7. Release the spindlelock.
8. To remove the disc, loosen the flange
14
with the two-
pinspanner.

WARNING: Do not use a damageddisc.
Fig. E1
Fig. E2
14
12
10
14
12
10
11
11
Fitting a Wire Cup Brush
Screw the wire cup brush directly onto the spindle without
the use of the spacer and threadedflange.
Fitting and Removing a Backing
Pad/Sanding Sheet (Fig. A, D, F)
The backing pad is available at extra cost from your local
dealer or authorized servicecenter.
1. Remove the guard from thetool.
2. Remove the backing flange
10
.
3. Place the rubber backing pad
15
correctly onto the
spindle
11
.
4. Place the sanding sheet
16
on the rubber backingpad.
5. Screw the threaded clamp nut
17
onto the spindle
11
.
6. Press the spindle lock button
2
and rotate the spindle
11
until it locks inposition.
7. Tighten the threaded clamp nut
17
with the two-
pinspanner.
8. Release the spindle lock
9. To remove the rubber backing pad, loosen the threaded
clamp nut
17
wih the two-pinspanner.
Fig. F
17
16
15
11
OPERATION

WARNING: Always observe the safety instructions
and applicableregulations.
• Ensure all materials to be ground are secured
inplace.
• Apply only a gentle pressure to the tool. Do not
exert side pressure on thedisc.
• Avoid overloading. Should the tool become hot,
let it run a few minutes under no load condition to
cool theaccessory.

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can causeinjury.