5
Sanding Paint
WARNING: Observe the applicable
regulations for sanding paint. Pay
special attention to the following:
• Wheneverpossible,useavacuumextractor
for dust collection.
• Takespecialcarewhensandingpaintwhich
is possibly lead based:
– Do not let children or pregnant women
enter the work area.
– All persons entering the work area should
weara mask specially designed for
protection against lead paint dust and
fumes.
– Do not eat, drink or smoke in the
work area.
• Disposeofdustparticlesandanyother
removal debris safely.
Residual Risks
In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
– Impairment of hearing.
– Risk of personal injury due flying particles.
– Risk of burns due to accessories becoming hot
during operation.
– Risk of personal injury due to prolonged use.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
DATE CODE POSITION
The Date Code, which also includes the year of
manufacture, is printed into the housing.
Example:
2015 XX XX
Year of Manufacture
Package Contents The package contains:
1 Palm grip sander
1 Dustbag
1 Sheet of sanding paper
1 Paper punch
1 Instruction manual
• Checkfordamagetothetool,partsor
accessories which may have occurred during
transport.
• Takethetimetothoroughlyreadand
understand this manual prior to operation.
Description (fig. 1)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
A. On/Off switch G. Side clamps levers
B. Front paper clamp H. Holding tabs
C. Front clamp button I. Vac-adapter
D. Base plate/pad J. Dust bag
E. Paper-limiting ribs K. Dust bag collar
F. Rear paper clamp
INTENDED USE
Your palm grip sander DWE6411 has been designed
for sanding of wood, metal and plastics in a
professional environment.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
This sander is a professional power tool. DO
NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• Thisproductisnotintendedforusebypersons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.
Electrical Safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D
WALT tool is double insulated in
accordance with EN 60745; therefore no
earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
service organisation.
Mains Plug Replacement
(Middle East and Africa)
If a new mains plug needs to be fitted:
• Safelydisposeoftheoldplug.
• Connectthebrownleadtotheliveterminalin
the plug.
• Connecttheblueleadtotheneutralterminal.