To Next PageTo Next PageHow to fix leaking tube fittings on DeWalt DWFP55130?
If you hear air escaping from the tube fittings on your DeWalt air compressor, tighten the fittings. You can also check the fittings with a soapy water solution to identify leaks. Be careful not to overtighten the fittings.
Why does the safety valve pop off on my DeWalt Air Compressor due to excessive air tank pressure?
The safety valve on your DeWalt Air Compressor might pop off due to excessive air tank pressure for several reasons: * The pressure switch may not be shutting off the motor when the compressor reaches the cut-out pressure. * The pressure switch cut-out might be set too high. * There may be a defective safety valve. * Tube fittings may not be tight enough. * The air tank may be defective and needs to be replaced, do not attempt to repair a leaking tank. * There may be leaking seals.
What to do if the safety valve keeps popping off on my DeWalt DWFP55130?
If the safety valve on your DeWalt Air Compressor keeps popping off, it could be due to several issues. First, try manually operating the safety valve by pulling on the ring; if it continues to leak, it needs replacement. Also, tighten any loose tube fittings where you hear air escaping, and check them with soapy water, being careful not to overtighten. If these steps don't resolve the issue, the pressure switch may not be shutting off the motor, the pressure switch cut-out may be too high, the air tank may be defective, or the seals may be leaking.
General| Type | Portable |
|---|---|
| Max Pressure | 200 PSI |
| Tank Capacity | 2.5 Gallons |
| Weight | 30 lbs |
| Air Flow Rate (SCFM at 90 PSI) | 2.6 SCFM |
| Power Source | Electric |
| Pump Type | Oil-Free |
| Voltage | 120V |
Explanation of DANGER, WARNING, CAUTION signal words and their severity.
Hazards from flammable vapors and electrical sparks.
Risks of inhaling contaminated air and chemical exposure.
Dangers related to air tank integrity, corrosion, and potential rupture.
Safety measures to prevent electric shock when operating the unit.
Dangers from compressed air streams propelling particles at high speed.
Explains proper grounding procedures to prevent electrical shock.
Lists frequent malfunctions, their causes, and corrective actions.
Provides solutions for specific issues identified by troubleshooting codes.
