DeWalt DWMT70783 - OPERATING PROCEDURES; START-UP and SHUT-DOWN; OPERATING INSTRUCTIONS; MAINTENANCE

14
English
OPERATING PROCEDURES
START-UP (FIG. 1, PG. 2)
•Connectthetooltoairsourcewiththehoseofrecommendedsize.
•Turnontheaircompressorandallowtheairtanktobefilled.
•Settheaircompressorregulatorto90PSI.Thisair
tool operates at a maximum of 90 PSI air pressure.
•Pushthe safety lever forward (1) while depressing the trigger (2)
to start operating the tool.
SHUT-DOWN (FIG. 1, PG. 2)
•Releasethetriggerinordertostopthetool.
•Fix/takeawaytheinserttool.
•Whenjobiscompleted,turnofftheaircompressorandstore
the air tool after lubrication. For safety, put the tool on
a hanger or on a soft flat pad when not in use.
•Whenchanginggrindingattachmentsandaccessories,
always disconnect the air supply to avoid injury.
OPERATING INSTRUCTIONS
•To begin operation, grip tool and depress safety throttle
lever while engaging the trigger.The tool will stop running when
the trigger is released.
 •Tomountstonesandotheraccessories,usethe
wrenches supplied with the tool. Always disconnect air
supply before changing any accessories.
 • Thegrindershouldbegraduallyappliedtotheworksurface
until the stone or burr becomes worn. Always replace
excessively worn stones or burrs.
 • Makesmoothcontactwiththeworkandavoidany
bumping action or excessive force.
MAINTENANCE
Lubrication
Air tools require lubrication throughout the lifetime of the tools.
The air motor and bearing uses compressed air to power the tool.
The compressed air contains moisture that will rust the air motor
and other parts in side of the tools, therefore lubrication is required
daily. Failure to lubricate the air tool properly will dramatically
shorten the life of the tool and will void the warranty
CAUTION: This air tool requires lubrication BEFORE initial use,
also before and after each additional use.
To Lubricate The Air Tool Manually:
1. Remove any attachment on the air tool.
2. Disconnect the tool from the air supply source, place
the air inlet face up.
3. Depress the trigger and place about 1 teaspoon
(5cc.) of air tool oil into the air inlet. (Depressing the trigger
will help circulate oil in the motor.)
2
1