To Next PageTo Next Page
Need help?Do you have a question about the DeWalt DWMT70782L and is the answer not in the manual?
The collet allows secure holding of insert tool mandrels. Collet nut and spindle have flat sides for assembly.
The trigger allows the operator to control the start and stop of the air tool.
The safety throttle lever prevents the tool from accidental actuation.
The body is aluminum for reduced weight and superior power-to-weight ratio, with an ergonomic grip.
The air inlet is at the bottom of the handle for connecting an air supply with a standard 1/4" NPT thread.
The exhaust is at the base of the handle, directing airflow away from the operator and work area.
The speed control screw increases or decreases the tool's rotary speed, adjustable with a flat screwdriver.
Recommended hook-up shown in Figure A. For efficiency and tool life, air pressure must not exceed rated PSI.
Designed for grinding/deburring in confined areas. Features rear exhaust, built-in regulator, and lock-off lever.
Tool should be used as hand-operated with solid footing. Secure position recommended for other positions.
Requires lubrication before initial, and before/after each additional use. Use clean, lubricated air supply at 90 psi.
Connect tool, turn on compressor, set regulator to 90 PSI, push safety lever, depress trigger.
Release trigger to stop. Fix/remove tool. Turn off compressor and store tool after lubrication.
Air motor and bearings need daily lubrication due to moisture in compressed air to prevent rust.
The air tool must be lubricated before storing. Follow lubrication instructions, omitting final running step.
General
