DeWalt DWP849X-XE - Components (Fig. 1)

5
CAUTION: Use extra care when working into a corner because a sudden, sharp
movement of the polisher may be experienced when the wheel or other accessory
contacts a secondary surface or a surface edge.
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ................. volts A ...............amperes
Hz ............... hertz W ..............watts
min ............. minutes ...........alternating current
........ direct current ...........alternating or direct current
.............. Class I Construction no ..............no load speed
................... (grounded) .............earthing terminal
.............. Class II Constr uction ..............safety alert symbol
................... (double insulated) BPM ..........beats per minute
…/min ........ per minute RPM ..........revolutions per minute
IPM ............. impacts per minute
SAVE THESE INSTRUCTIONS FOR FUTURE USE
Motor
Be sure your power supply agrees with the nameplate marking. Voltage decrease of
more than 10% will cause loss of power and overheating. DEWALT tools are factory
tested; if this tool does not operate, check power supply.
COMPONENTS (FIG. 1)
WARNING: Never modify the power tool or any part of it. Damage or personal
injury could result.
A. Speed control wheel G. Trigger locking button
B. Main handle H. Bale handle
C. Variable speed trigger switch I. Spindle
D. Brush inspection cap J. Soft rubber gear case cover
E. Spindle lock button K. Wool ingestion shield
F. Auxiliary handle
FIG. 1
C
H
E
I
D
G
A
K
J
B
F
INTENDED USE
The DWP849X-XE heavy-duty polisher is designed for polishing painted or unfinished
metal, fiberglass, and composite surfaces in professional applications. Common
examples of use include but are not limited to: auto/marine/RV/motorcycle detailing
and finish correction, boat construction and repair, and metal or concrete finishing.