8
English
Storage (Fig. 12)
1. Empty the canister, refer to
To Empty Canister under
Operation.
2. Clean the vacuum inside and
outside.
3. Clean or replace filters,
refer to Filters.
4. Store the suction hose and the
power cord as shown in the
illustration. Place the unit in a
dry room and secure it from
unauthorized use.
NOTE: Plug inlet plug (S) into inlet (J) to keep debris inside
canister when suction hose is removed. You can also attach the
ends of the hose together and lock together with the twist-lock
end.
Accessories
WARNING: Since accessories, other than those offered by
D
EWALT, have not been tested with this product, use of such
accessories with this tool could be hazardous. To reduce the risk
of injury, only D
EWALT recommended accessories should be used
with this product.
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service center.
If you need assistance in locating any accessory, please contact
D
EWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
21286, call 1-800-4-D
EWALT (1-800-433-9258) or visit our website
www.dewalt.com.
J
S
FIG. 12
OPTIONAL ACCESSORIES
DWV9320 (some models)
DWV9330 (some models)
HEPA filter: Captures
99.97% of all particles
greater than or equal to 0.3
microns. Required when
picking up lead paint debris.
DWE46100
5"–6" (127–152 mm)
Cutting/tuckpointing shroud
DWE46150
5" (127 mm) Cutting/
tuckpointing shroud
DWH050K
DWH050 drilling dust
extraction system
DWH052K
DWH052 demolition dust
extraction system
DWH053K
DWH053 chipping dust
extraction system
DWV9316 Anti-static 14' (4.3 m) hose
To Next Page
Loading...
