TROUBLESHOOTING
If the supply cord is damaged, it
TO REDUCE THE RISK OF INJURY
FROM MOVING PARTS AND/OR
ELECTRIC SHOCK, TURN POWER
SWITCH OFF AND DISCONNECT
GROUNDED PLUG FROM ELECTRICAL
OUTLET BEFORE PERFORMING
TROUBLESHOOTING CHECKS.
Minor problems often can be xed without
calling customer service.
must be replaced by the manufacturer, its service
order to
avoid a hazard.
PROBLEM CAUSE
SOLUTION
1. Plug unit in.
2. Place in "ON"
position.
1. Contact customer
service.
1. Contact customer
service.
1. Check for
obstructions. If you
turn the fan off. Unplug
the fan and carefully
remove the obstruction.
Plug the fan in and turn
it on again by referring
to the operating
instructions.
Unit will not
run.
Unit is not
rotating.
Unit runs but
the fan
makes loud
scraping
noise.
Unit runs but
vibrates
excessively.
1. No power to unit.
2. Switch not on.
1. Obstructions are
keeping the fan
from working.
1. Unit has been
severely jolted
causing fan blade
to rub against
housing or
housing to deform.
1. Dirt build up on
fan blade.
2. Severe jolt has
bent motor shaft.
TOOL GUARANTEE
ARNING: W
ARNING: W
YEAR
LIMITED
GUARANTEE
5
6
ENGLISH
To Next Page
Loading...
