To Next PageTo Next PageHow to stop my DeWalt DXH330 Heater from running continuously?
If your DeWalt Heater is running non-stop, try these solutions: * Verify the thermostat settings. * Consider whether heat losses exceed the unit's capacity or if the unit is undersized for the space.
Why my DeWalt DXH330 does not work?
If your DeWalt Heater isn't working, here are a few things to check: * Ensure the thermostat is correctly set. * Inspect the circuit breaker or fuse. * Check if the thermal overload switch has tripped. * Examine for faulty connections. * Make sure the plug and outlet are not damaged.
What to do if elements are on but motor does not rotate on DeWalt DXH330 Heater?
If your DeWalt Heater elements are on, but the motor isn't rotating, consider these possibilities: 1. The motor might be faulty. 2. The fan blades could be blocked.
Why is the enclosure of my DeWalt Heater extremely hot?
If the enclosure of your DeWalt Heater is getting extremely hot, here are a few things to investigate: * There may be a faulty thermal protection. * The air vents might be blocked. * The motor could be faulty.
What causes overheating in DeWalt DXH330 Heater?
If your DeWalt Heater is overheating, consider the following: * Check the thermostat or wrong thermostat setting. * The motor could be faulty.
What to do if desired room temperature cannot be reached with DeWalt Heater?
If the desired room temperature cannot be reached with your DeWalt Heater, consider these potential issues: * One or more heating elements might be defective. * The thermostat setting might be incorrect. * The voltage may be lower than specified on the rating tag. * Heat losses might exceed the unit's capacity, or the unit could be undersized. * There may be a cold airflow affecting the heater's performance.
Why does my DeWalt Heater emit a humming sound?
If your DeWalt Heater emits a humming sound, here are a few things to check: * The motor could be faulty. * The fan blade might be blocked. * There may be a defective contact.
What causes some or all of the elements to not rotate on DeWalt Heater?
If some or all of the elements on your DeWalt Heater do not rotate, consider these potential issues: * The motor could be faulty. * The fan blades might be blocked.
General| BTU Output | 330, 000 BTU |
|---|---|
| Fuel Type | Propane |
| Ignition Type | Electronic |
| Safety Features | Overheat Shut Off |
| Heater Type | Forced Air Heater |
Steps to safely turn off the electric forced air heater after use.
Diagnoses for when the heater fails to operate.
Troubleshooting common causes for continuous operation.
Identifies issues when heating elements are active but the fan is not.
Addresses overheating of the heater's exterior.
Solutions for when the heater fails to heat the room adequately.
Troubleshooting steps for persistent overheating issues.
Diagnoses for unusual humming noises from the heater.
Schematic representation of the electrical connections for the DXH330 model.
Schematic representation of the electrical connections for the DXH1000 model.
